Hyundai Santa Cruz: Engine Mechanical System / Special Service Tools
| Tool (Number and name) | Illustration | Use |
| Crankshaft front oil seal installer 09214-L1100 Handle 09231-H1100 |
| Installation of the crankshaft front oil seal |
| Valve stem seal installer 09222-4A000 |
| Installation of the valve steam seal |
| Valve spring compressor 09222-3K000 Valve spring compressor adapter 09222-3K100 |
| Removal and installation of the intake or exhaust valve spring & retainer lock |
| Crankshaft rear oil seal installer 09214-L1200 Handle 09231-H1100 |
| Installation of crankshaft rear oil seal |
| Ring gear stopper 09231-2B100 |
| Removal and installation of crankshaft damper pulley bolt |
| Ring gear stopper 09231-3D100 09231-2W100 |
| Removal and installation of crankshaft damper pulley bolt. A : 09231 - 3D100 B : 09231 - 2W100 |
| Oil pan remover 09215-3C000 |
| Removal of oil pan |
| A: E-CVVT plug installer B: E-CVVT cover installer C : handle wheel 09243-C2000 |
| Installation of E-CVVT assembly plug Installation of E-CVVT cover |
| Water pump belt remover & installer 09252-C1000 |
| Removal and installation of water pump belt |
Specifications
- Specifications
DescriptionSpecificationsLimit
General
TypeIn-line, DOHC
Number of cylinders4
Bore88.5 mm (3.484 in.)
Stroke101.5 mm (3.996 in.)
Total displacement2497 cc (152.38 ...
Repair procedures
- Compression Pressure Inspection
• If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure.
1.Start the engine until ...
Other information:
Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: Auto Light Sensor
- Inspection
Check if the auto light control operates like a timing chart shown
below.Tail lamp output and head lamp (Low) output is controlled based on
the auto light sensor's input (illumination intensity) when the Auto
Light Switch in Multi-Function Switch is turned ON, and the vehicle i ...
Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: Repair procedures
- Adjustment
1.After loosening the hinge (A) mounting bolt, adjust the hood (B)
by moving it up and down or from side to side and tighten the bolt.
2.Adjust the hood height by moving the hood overslam bumpers (C) up and down.
3.After loosening the hood latch (D) mounting bolts, adjust the l ...
