Hyundai Santa Cruz: Dual Clutch Transmission System / Special Service Tools
| Tool (Number and Name) | Illustration | Use |
| 09200-3N000 Engine support fixture (Beam) |
| Removal and installation of the transaxle. Use this beam (SST No. : 09200-3N000) with the supporter (SST No. : 09200-2S200). ※Permit operating with 09200-38001. |
| 09200-2S200 Engine support fixture (Supporter) |
| Removal and installation of the transaxle. with the beam (SST No. : 09200-38001/3N000). |
| 09200-L1200 Engine support fixture (Front) |
| Removal and installation of the transaxle. with the beam (SST No. : 09200-38001/3N000). |
| 09200-2W000 Adaptor |
| Removal and installation of the transaxle. with the beam (SST No. : 09200-38001/3N000). |
| Oil seal installer 09453-3L240 |
| Used for installing transmission case side oil seal Used with the handle (09231 - H1100) |
| Oil seal installer 09430 - 2C800 |
| Used for installing transmission case and housing oil seal (4WD) Used with the handle (09231 - H1100) |
| Oil seal installer 09473-D3500 |
| Driven gear oil seal installing (4WD) |
| 0K431-P2100 Oil seal installer |
| Used for installing transmission housing side oil seal (2WD) [Using with bar (SST No.09231-H1100)] |
| 09231-H1100 Bar |
| Installation of the differential oil seal in the transaxle case and housing side. [Using with oil seal installer (SST No.:0K431-P2100)] |
| 09480-A3800 Position switch neutral fixed pin |
| When installing the manual control lever on the position switch, used to align the neutral position. |
| 0K430-P2100 Dual clutch remover and installer |
| moval and installation of the dual clutch. |
| 0K430-P2200 Dual concentric slave cylinder moving tool |
| Removal and installation of the dual concentric slave cylinder |
Specifications
- Specifications
Transmission modelSmartstream Wet 8th DCT(D8LF1)
Engine modelTheta III 2.5 T-GDI (Gasoline)
Gear ratio1st3.429
2nd2.217
3rd2.217
4th1.621
5th0.860
6th0.673
7th0.791
8th0.6 ...
Troubleshooting
- Troubleshooting
Trouble symptomProbable causeRemedy
Displayed the warning lamp "E"(Driving is only possible with 1/ R gear)Not performed DCT learningPerform the DCT manual learning procedure.
I ...
Other information:
Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: Repair procedures
- Inspection
[Evaporate Leakage Test]
1.Select "Evap. Leakage Test".
2.The test shall be conducted in accordance with diagnostic tool instructions.
Evap. Leakage Test Enable Condition – Engine idle
– No DTC
– Fuel Amount : 15 - 85%
– P, N - Lever (or Neutral ...
Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: Troubleshooting
- Troubleshooting
• Be careful not to short-circuit the wiring by the body or other wirings.
• In case of discharging problem, measure dark current at all times. (Charging System - "Dark Current Inspection")
• When checking the alternator main fuse, perform continu ...
