Hyundai Santa Cruz Owners & Service Manuals

Hyundai Santa Cruz: Convenient Features / Sunroof

If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof switch located on the overhead console.

The sunroof can only be operated when the ignition switch or Engine Start/Stop button is in the ON or START position.

The sunroof can be operated for approximately 3 minutes after the ignition switch or Engine Start/Stop button is in the ACC or LOCK/OFF position. However, if the front door is open, the sunroof cannot be operated even within the 3 minute period.

WARNING

  • Never adjust the sunroof or sunshade while driving. This could result in loss of control and an accident that may cause injury, or property damage.
  • Do not leave the engine running and the key in your vehicle with unsupervised children. Unattended children could operate the sunroof, which could result in serious injury.
  • Do not sit on the top of the vehicle. It may cause injury or vehicle damage.

NOTICE

Do not operate the sunroof when roof bars are installed on the vehicle or when there is luggage on the roof.

Rear Sliding Window
Your vehicle is equipped with a rear sliding window behind the rear seats. Opening the rear sliding window Push the lock release lever and slide the rear sliding window to the left. Closing the rea ...

Sunshade
Use the sunshade to block direct sunlight coming through the sunroof glass. Open or close the sunshade by hand. Information The sunshade opens automatically when the sunroof glass is opened, but th ...

Other information:

Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: Rear Hub - Carrier
- Components 1. Rear brake disc2. Rear hub assembly3. Dust cover4. Rear carrier assembly - Removal [2WD]     • When lifting a vehicle using a lift, be careful not to damage the lower parts of the vehicle (floor under cover, fuel filter, fuel tank, canister).(Refer ...

Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: Door Garnish
- Replacement     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Put on gloves to prevent hand injuries. 1.Loosen the mounting nuts, remove the front door garnish (A) and rear door garnish ...

© 2023-2025 Copyright www.hysacr.com