Hyundai Santa Cruz: Steering System / Specifications
| Item | Specification | |
| Type | Electric Power Steering System | |
| Steering gear | Type | Rack & Pinion |
| Rack stroke | 152 ± 1 mm (5.98 ± 0.04 in) | |
| Steering angle (Max.) | Inner | 36.9˚ (+0.5˚/-1.5˚) |
| Outer | 32.1° | |
| Item | Tightening torque (kgf.m) | ||
| N.m | kgf.m | lb-ft | |
| Tire wheel Hub nuts | 107.9 - 125.5 | 11.0 - 13.0 | 79.6 - 94.0 |
| Steering wheel lock nut | 44.1 - 49.0 | 4.5 - 5.0 | 32.5 - 36.2 |
| Steering column assembly to Universal joint | 53.9 - 58.8 | 5.5 - 6.0 | 39.8 - 43.4 |
| Universal joint to steering gear box | 49.0 - 58.8 | 5.0 - 6.0 | 36.2 - 43.4 |
| Steering column mounting bolts | 53.9 - 58.8 | 5.5 - 6.0 | 39.8 - 43.4 |
| Steering column mounting nuts | 24.5 - 29.4 | 2.5 - 3.0 | 18.1 - 21.7 |
| Tie rod end castle nut | 98.1 - 117.7 | 10.0 - 12.0 | 72.3 - 86.8 |
| Tie rod end nut | 49.0 - 53.9 | 5.0 - 5.5 | 36.2 - 39.8 |
| MDPS motor mounting bolt | 15.0 - 21.9 | 1.53 - 2.24 | 11.0 - 16.2 |
| Steering gear box heat protector mounting bolt | 6.8 - 10.7 | 0.7 - 1.1 | 5.0 - 7.9 |
| Steering gear box to sub freame | 107.9 - 127.5 | 11.0 - 13.0 | 79.6 - 94.0 |
| Lower arm to knuckle | 98.1 - 117.7 | 10.0 -12.0 | 72.3 - 86.8 |
Steering System
...
Special Service Tools
- Special Service Tools
Tool (Number and Name)IIIustrationUse
09568-2J100Ball joint remover
Removal of the tie rod end ball joint.
09568-4R100Lower arm ball joint remover
Removal of the lower ar ...
Other information:
Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: Rear Glass Defogger Printed Heater
- Inspection
Wrap tin foil around the end of the voltmeter test lead to prevent
damaging the heater line. Apply finger pressure on the tin foil, moving
the tin foil along the grid line to check for open circuits.
1.Turn on the defogger switch and use a voltmeter to mea ...
Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: General Service Information
- General Service Information
Protection of the VehicleAlways be sure to cover fenders, seats, and floor areas prior to beginning work.
• The support rod must be inserted into the hole near the edge of the hood whenever you inspect the engine compartment to prevent the hoo ...
