Ventilation
1. Set the mode to the position.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed control to the desired speed.
Heating
1. Set the mode to the position.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed control to the desired speed.
5. If desired, turn the air conditioning ON with the temperature control knob set to heat in order to dehumidify the air before it enters into the cabin.
If the windshield fogs up, set the mode
to the or
position.
Operation Tips
Air conditioning
HYUNDAI Air Conditioning Systems are filled with R-1234yf refrigerant.
1. Start the vehicle.
2. Press the air conditioning button.
3. Set the mode to the Face Level
mode.
4. Set the air intake control to Recirculation mode temporarily to allow the cabin to cool quickly. When the desired temperature in the cabin is reached, change the air intake control back to Fresh mode.
5. Adjust the fan speed control and temperature control to maintain maximum comfort.
When maximum cooling is desired, set the temperature control to the lowest position, then set the fan speed control to the highest setting.
NOTICE
Air conditioning system operation tips
Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: Rear Stabilizer Bar
- Removal
• When lifting a vehicle using a lift, be careful not to damage
the lower parts of the vehicle (floor under cover, fuel filter, fuel
tank, canister).(Refer to General Information - "Lift and Support
Points")
1.Raise the vehicle, and make sure it is securely ...
Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: Repair procedures
- Inspection
Tolerance Calibration Outline
• SVM calibration tool is required to perform tolerance calibration as shown below.
• Refer to the information below to purchase the SVM calibration tool.
– Tool Name : GDS SVM HYUNDAI (SVM-100)
– Representative purc ...