Hyundai Santa Cruz: Light Bulbs / High Mounted Stop Lamp and Top Mounted Bed Lamp / Side Mounted Bed Lamp Replacement
.jpg)
[A] : High Mounted Stop Lamp
[B] : Top Mounted Bed Lamp
If the LED light source does not operate, have the system be inspected by an authorized HYUNDAI dealer.
The LED light source cannot be replaced as a single unit because it is an integrated part of the lamp. The LED lamp has to be replaced as a unit.
A skilled technician should check or repair the LED lamp, because it may damage related parts of the vehicle.
Rear Combination Lamp
Replacement
(1) Tail lamp
(2) Turn signal lamp/ Stop Lamp
(3) Tail lamp
(4) Rear side marker
Turn signal lamp/ Stop lamp
1. Turn off the engine.
2. Open the tailgate.
3. Remove the lamp assembly retaining
bolt ...
License Plate Lamp Replacement
1. Using flat-blade screwdriver, gently
pry on the inside edge of the lamp
housing, compressing the metal clip
on the opposite side. Once clip is
compressed, lamp will rotate out of
location in ...
Other information:
Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: Troubleshooting
- Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection Procedure
Measuring Condition of Electronic Parts' ResistanceThe measured
resistance at high temperature after vehicle running may be high or low.
So all resistance must be measured a ...
Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: Fuel Pressure Regulator
- Removal
[A type]
1.Remove the fuel pump.(Refer to Fuel System - "Fuel Pump")
2.Disconnect the fuel sender connector (A).
3.Release the fixing hook (A) and then remove fuel sender (B) in the arrow direction.
4.Remove the fixing pin (A) and then disconnect the fuel feed tube (B).
5.Di ...
