Hyundai Santa Cruz: Automatic Climate Control System / Manual Heating and Air Conditioning
1. Start the engine.
2. Set the mode to the desired position. For improving the effectiveness of heating and cooling, select:
- Heating: 
- Cooling: 
3. Set the temperature control to the desired position.
4. Set the air intake control to the outside (fresh) air position.
5. Set the fan speed control to the desired speed.
6. If air conditioning is desired, turn the air conditioning system on.
7. Press the AUTO button to convert to full automatic control of the system.
Automatic Heating and Air
Conditioning
The Automatic Climate Control System
is controlled by setting the desired
temperature.
1. Press the AUTO button.
The modes, fan speeds, air intake and
air-conditioning will be controlled
automatic ...
Mode selection (12)
The mode selection button controls the direction of the air flow through the
ventilation
system.
The air flow outlet direction is cycled as
follows:
Air flow is directed toward the upper
body ...
Other information:
Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: Rear Driveshaft
- Components
1. Rear drive shaft
- Removal
• When lifting a vehicle using a lift, be careful not to damage
the lower parts of the vehicle (floor under cover, fuel filter, fuel
tank, canister).(Refer to General Information - "Lift and Support
Points")
1.Loos ...
Hyundai Santa Cruz (NX4A OB) 2021-2025 Service Manual: Front Seat Shiled Outer Cover
- Component Location
1. Front seat shield outer cover
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
...
